HANDLING AND MAINTAINING.

1. Apply balm before the blow
   Avoid dirt and sand entering by putting a rug at the entrance of the room. You can do more by putting two rugs, one at the outer side of the door and the other at the inner side of the door.
2. Sweeping/vacuuming
   The way the parquet you had bought was processed in addition to the number of lacquer layers which covers it, prevent dirt, dusk and grease from getting caught in it. This is another opportunity to thank the manufacturers and technology, because all that is left for you to do is to sweep/vacuum the dirt which flows on the floor and afterwards to go over the surface with a wet rag (you have to pay attention that the rag does not leaking and leaves water drops).
3. Periodic handling (does not refer to synthetic parquet)
   The periodic handling will be done with the help of cleaning substances of the known BONA, manufacturer of the lacquer which covers the parquet you own. These cleaning substances contains the pigments which constitutes the lacquer , and therefore are the most suitable in order to protect and keep the parquet floor.
   First, use the CLEANER, in a dose of eight plugs for half a bucket of water. The CLEANER cleans, refreshes and renews the lacquer.
   After diluting the required amount (with respect to the surface size) deep the rag and go over the surface. It is better to wait a few minutes that the surface will dry and to go over the surface with the rag a few more times.
   Use same manner and dosage for the POLISH which creates a protective layer and gives shine and smoothness to the surface.
   
   If you have yet to purchase the cleaning substances, harry to call us and order.
   
   For more information contact us and we will be happy to help.